Flower Bow Headband
For the manufacture of the rim "Flower Bow" you will need: - a narrow ribbon of light lilac color. - a plastic bezel 1.3 cm wide. - scissors. - pink-colored rhinestones with a diameter of 4 mm . - lighter. - wide pink ribbon made of satin. - ribbon made of satin fuchsia of medium size width. - lilac felt. - glue gun. - piece Decorative braid, imitating silvery rhinestones. Sequence of work. First you need to process the bezel.On its flat surface, the future bow will not hold well, it will require a narrow ribbon.The edge of the light lilac ribbon needs to be singed so that it does not crumble while the rim is worn. Then this narrow tape should wrap the bezel, not forgetting to make uniform distances between each turn.It is not necessary to make frequent entanglements of the rim, the main thing is to cover the main part of the rim surface. Glue should be spread evenly and along the entire line of contact between the tape and the rim. It is important to ensure that the glue surplus does not protrude beyond the limit of the tape.Temporarily you can remove the bezel so that it does not interfere, and proceed to create a floral bow. For this you need a wide ribbon, from which you need to prepare squares with sides of 50 mm. A total of such blanks for the rim will require 24 pieces.You need to make three-dimensional parts from each square. Taking up one blank, you need to bend it, focusing on the diagonal line, to make a triangle.The resulting blank need to be folded now in half, and repeat the action twice more. The result is a triangular part,bent in four layers.Having arranged the cuts to the bottom, you need to cut them with scissors, correcting possible irregularities and immediately singe with fire, to solder together. It is important to do this carefully so that the tape does not burn down and does not become covered with black opalines, but each layer of the fabric must be processed.At the place of singing a strong seam was formed. The whole petal at this place must be turned.The volume petal is ready, it remains to make the same from other pink squares.This action must be repeated with all the leaves and petals by combining them. Now you can start collecting a bow. To create the first row you need to glue together two petals,combining their side parts. In the second row you need to place the details on the bottom side of the first level. Three petals should be glued between the parts of the first row.
Now for each petal you need to make a leaf. For this you need a fuchsia ribbon of average width. From it should be prepared segments of 4.5 cm. Their total number should correspond topetals.All the leaves should also be created separately. Taking the first segment in hand, you need to place it face up.Then fold the entire length in half, combining the edges, and hiding the inside of the wrong side.Squeezing the fold line with your fingers, you need to cut off the top corner under the small a little tilt. At the same time the fold should remain unchanged.Oblique cut you need to sing, while soldering tape folding together.You can straighten the workpiece, the petal is almost ready.From other segments you need to make similar leaves.Next, the petals and leaves must be aligned. The bottom of the petal should be smeared with glue and attached to the pointed part of the leaf, retreating 2-3 mm.The bottom cut of the leaf requires a petal to wrap on both sides.Holding in this position, the cut must be processed by fire, soldering.
How to choose the cottage cheese
The best lipsticks and glitter with metallic effect
What is a bus
How to cook a delicious cake - 12 step-by-step recipes with video