• Rust removal with citric acid

    This is one of the simplest, safest and most effective ways to remove rust from the surface of old steel tools. The difference between this method is that no scarce reagent or expensive equipment will be required to restore the metal surface. All that is required is practically in any kitchen.
    Rust removal with citric acid

    Materials

    • Citric acid powder - sold in a culinary shop or pharmacy if you do not turned out to be her home.
    • A container where we will immerse steel items for recovery.
    • A scraping device such as a spatula. Or a brush on metal.
    For safety:
    • Rubber gloves.
    • Protective glasses.
    Benefits of using citric acid:
    • Does not remove paint on the surface.
    • The reaction is fully controlled.
    • Very affordable - almost always available in the kitchen.
    • After use, you can pour it into the sink.
    • Much cheaper,

    Cleaning the surface of parts

    The first thing you need to do is to clean the surfaces of dirt and degrease. You can use a washing sponge, a dishwashing net and a detergent for this.
    Removing rust with citric acid
    Removal of rust by citric acid
    We wash and clean the surfaces of parts and tools before restoring and rust.

    Preparation of the solution

    To prepare the solution, you must take a plastic container where all rust removal items fit.
    Preparation of the solution
    Pour into this container the required amount of warm water, degrees 60 - 40 Celsius. With the volume of water to overdo it is not necessary, since it will take a lot of citric acid. Add the powder of citric acid approximately at the rate of 60-80 grams per 100 ml of water. This is quite a lot and the solution will turn out to be quite concentrated. All proportions are experimental, so you can look for your golden proportion. Fall asleep in water and stir until fulldissolution.

    Restoration of rusted surfaces

    Restoration of rusted surfaces
    Restoration of rusted surfaces
    Restoring rusted surfaces
    We lower the steel objects in the solution. After a few minutes, small bubbles begin to form on the surface, indicating a normal reaction. After 30-60 minutes, no rust will appear on the surface of the solution. Cleaning parts with a sponge or metal brush will help speed up the process. Sometimes 60-90 minutes is enough to restore the surface of not very rusted objects. Some citric acid can be added to an existing solution, if necessary, to speed up the reaction. We wait until the rust disappears completely. I left massive parts planer for 7 hours, although most of the items recovered within 2-4 hours. When you have finished - the solution can be safely poured into the sink, as it is non-toxic.

    Protective oil coating

    Protective oil coating
    After removing the parts from the solution, rinse them with water and dry. In addition to removing rust, the citric acid solution left an oxide film on the steel surface that will protect the metal for a short time. But in order to protect the surface as much as possible, treat it with engine oil. If there is no motor, take a sunflower, it will be better than nothing.

    The result of removing rust

    The result obtained using this method.
    Result of removing rust
    Result of rust removal
    This method removes corrosion in all hard-to-reach places, retains the original mark if it is available, which is impossible with mechanical rust removal by sandpaper. Recovered surfaces can be cleaned without any problems to shine with felt or wool with Goi paste.

    Related news


    How to play for money
    How to give flowers
    How to hide audio recordings in Vkontakte
    How to treat osteochondrosis
    How to upload to ipad
    Furniture hinges
    Why are avocado masks useful?
    Advise some good CRM system